Log in is not required to search. In the red banner above select: I Want To > Search > Permits

Code Enforcement Detail

Code Enforcement Detail
Case Number	CE16120277	complainant
Case Date	12-30-2016	address
Origination	-	Status	C - CLOSED
Operator	nsulliva	Officer	ERIC
Fines Balance	$0.00
Lien Balance	$0.00
Total Balance	$0.00
Property On Case
STRAP NBR	C-14-37-29-050-0450-0010	Owner	BENNETT E D + EDITH J-LAINE
Unit		Owner Address	131 MCKINLEY AVE
Property Address	131 MCKINLEY AVE	City/State/Zip	LAKE PLACID FL 33852
City/State/Zip	LAKE PLACID FL 33852	Phone

Case Description

NEW AIR CONDITIONING SYSTEM INSTALLED BY

ABSOLUTELY COOL INC NOT PRPPERLY INSTALLED

THEREFORE SYSTEM NOT PROPERLY WORKING, MOLD AND

MILDEW . NO PERMIT

Inspections/Events Detail

DATE	TIME	INSPECTION / EVENT TYPE	INSTRUCTIONS / COMMENTS
05-01-2017	07:02 PM	CLOSE COMPLAINT	CASE CLOSED BY ELONGSHO
05-01-2017	07:02 PM	REINSPECTION	HAD MEETING WITH CONTRACTOR WHO ZAID HE WOULD CORRECT IZZUEZ WITH INZTALLATION. LATER CONFIRMED WITH OWNER THAT CORRECTIONZ HAVE BEEN MADE CLOZE CAZE.
01-06-2017	05:08 PM	INITIAL INSPECTION	ARRANGED MEETING WITH OWNER TO INSPECT A/C INSTALLATION AND DISCUSS CONCERNS WITH JOB. THERE ARE SOME ISSUES WITH THE INSTALLATION, THE CEILING IS NOT SEALED AROUND THE RETURN DUCT ALLOWING THE INSULATION FROM THE ATTIC TO FALL INTO THE HOME AND THE COMPRESSOR UNIT IS NOT ANCHORED DOWN. THE CUSTOMER ALSO HAS CONCERN THAT THE UNIT IS NOT FUNCTIONING PROPERLY. WHILE I WAS THERE THE UNIT WAS SET ON 72 DEGREES AND THE OUTSIDE TEMERATURE WAS 74 DEGREES. I WAS THERE FOR 30-45 MINUTES DOING INSPECTION AND THE UNIT RAN CONTINUOSLY NEVER SHUTTING DOWN. A POSSIBLE FLAW MAY BE THAT THE SUPPLY PLENUM IS DOWNSIZED DUE TO A TRUSS MEMBER OVER THE UNIT PLACEMENT. THE CUSTOMER ALSO SHARED THAT WHILE ADDING INSULATION TO THE ATTIC IT WAS DISCOVERED THAT A SUPPLY DUCT WAS DAMAGED AND DISCONNECTED. REPAIRS WERE MADE BY OWNER. THERE IS ALSO MOLD AROUND SOME OF THE DIFFUSERS. OWNER SAYS THAT HE CLEANS THEM BUT THE MOLD RETURNS. THE CEILING WILL HAVE TO BE SEALED AROUND THE RETURN DUCT. THE COMPRESSOR WILL HAVE TO BE ANCHORED DOWN. THE UNIT WILL HAVE TO BE CHECKED FOR PROPER FUNCTION AND AIR FLOW. THE CAUSE OF THE MOLD AT THE DIFFUSERS WILL HAVE TO BE INVESTIGATED AND REMEDIED AND ALL OF THE DUCTWORK WILL HAVE TO BE CHECKED AND CERTIFIED TO MEET CURRENT CODE REQUIREMENTS.
12-30-2016	04:39 PM	CREATE COMPLAINT	COMPLAINT RECORDED BY NSULLIVA

Copyright © 2008 – THE PLUS SERIES ® – All Rights Reserved